<h2>Prepare Before Removing the First Piece</h2>
<p>A successful wooden model build begins before assembly. Choose a clean, flat surface with good lighting and enough room for the instruction manual, wooden boards and completed sections.</p>
<p>Read through the opening steps so you understand how parts are identified. Keep a small tray nearby for loose components and avoid placing drinks directly beside the model.</p>
<h2>Work in the Order Shown</h2>
<p>Instructions are designed around a specific assembly sequence. A component that appears accessible at the beginning may become difficult to install once the surrounding structure is complete.</p>
<p>Complete one stage before moving to the next and compare the orientation of each piece with the illustration. Symmetrical parts can still have different positions inside the mechanism.</p>
<h2>Remove Parts Carefully</h2>
<p>Support the wooden board close to the part you are removing. Work gradually around the connection points instead of pressing hard on one edge.</p>
<p>Take extra care with thin decorative elements, narrow axles and small gear teeth. Remove only the pieces required for the current step so that similar parts remain easy to identify.</p>
<h2>Do Not Force Parts Together</h2>
<p>Resistance is a signal to stop and inspect the connection. Check the part number, direction and slot before applying additional pressure.</p>
<p>A forced connection can damage a part or create tension that affects the final mechanism. Careful alignment is more effective than strength.</p>
<h2>Test Moving Sections During Assembly</h2>
<p>When gears, wheels, levers or axles are installed, test their movement before covering them with the next structural layer. Components should move in the intended direction without obvious obstruction.</p>
<p>If movement feels restricted, compare the assembly with the previous instruction steps. Look for reversed parts, excessive pressure or an axle that is not fully aligned.</p>
<h2>Common Assembly Mistakes</h2>
<ul>
<li>Removing too many parts at once and losing track of their numbers.</li>
<li>Installing a symmetrical-looking component backwards.</li>
<li>Skipping a movement check before closing the mechanism.</li>
<li>Forcing a tight connection instead of checking alignment.</li>
<li>Rushing through repeated sections and missing a small difference.</li>
<li>Building on an uneven or poorly lit surface.</li>
</ul>
<h2>What to Do if You Get Stuck</h2>
<p>Return to the last stage where the model matched the instructions exactly. Compare each visible part with the diagram and check whether the current section can be safely adjusted.</p>
<p>Do not continue adding parts when the mechanism is clearly misaligned. Correcting the issue early usually saves time.</p>
<h2>Finish With a Final Check</h2>
<p>After completing the model, inspect all visible connections and test the moving features according to the product instructions. Remove loose wooden dust with a soft, dry brush.</p>
<p>The goal is not simply to reach the final step. A careful build creates a model that looks better, moves more smoothly and reflects the time invested in its assembly.</p>
